March 2, 2017 2:21 am
"Swapping out light bulbs, turning on ceiling fans, and replacing air filters are a few easy ways to save energy," says Eric Corbett, president and owner of Larry & Sons. "Even the smallest problems with your furnace or inconsistencies in heating effectiveness throughout your home can cause your energy bill to skyrocket during winter."
Corbett offers the following tips on how to save energy and lower utility bills during winter:
- Seal the doors and windows. Homes are built to protect you from the elements. However, over time the seals around doors and windows can become weak. You may find that the seals between your doors and window frames are not as tight as they once were when the home was brand new. Weakened seals allow cold air to enter and warm air to exit. Therefore, heating your home isn't working if your seals are weak.
- Run your fans. Turning on the indoor fans will help to move air around the room. This evens out the temperature in a room instead of the hot air accumulating near the ceiling. It also helps to eliminate any cold spots in corners of the home.
- Swap old bulbs for LED lights. Swapping out old incandescent lights for LED lighting can save you extra money over time. In addition to being more energy efficient, LED lights last up to 50 times longer than incandescent lights and up to five times longer than fluorescent ones. This saves you time and money replacing burnt out bulbs.
- Turn down your thermostat and water heater if you're leaving home. If you are traveling, turn down the thermostat and water heater before leaving your home. Don't completely shut them off, just turn them down to save energy. If you shut your thermostat and water heater off, pipes can freeze without sufficient warmth.
- Install a programmable thermostat. A programmable thermostat allows you to set the temperature for various times of the day so that your furnace turns on to warm your house before you wake up, or it shuts off to save energy when everyone is asleep.
- Call a professional. Your HVAC is a complex system. If it's malfunctioning and runs without repair, it could potentially lead to greater damage and a more expensive repair. Invest in routine low-cost maintenance and tune-ups to save money in the long run.
- Clean your furnace filter. The simplest thing to do is to replace your air filter often. An HVAC unit drives air through a filter into the ductwork to the rest of the house. This keeps your air clean and filtered for impurities. As the filter removes impurities and dust from the air, it blocks airflow causing the furnace to work harder, which draws more energy.
Published with permission from RISMedia.